Ihr direkter Kontakt zu uns

(Mo-Fr 08:00 - 17:00 Uhr)

+49 (89) 264860-0

info.de@mbbm-vas.com

ICP42 G2

0%

    Where to use

    The ICP42 G2 Module can be used with ICP® based accelerometers, force and pressure sensors as well as to measure analog voltages. All 4 channels operate independently of each other, each with their own setting of mode, gain and coupling.

    • With any ICP® based sensor commonly used to measure vibration, acceleration, force or pressure
    • With any voltage source up to ±10 V in voltage input mode

    Features

    • 4 channels
    • 2 input modes of operation:
      • ICP® mode with 4 mA constant current at ±12 V or 24 V excitation
      • Voltage input mode with AC or DC coupling
    • Supports TEDS IEEE 1451.4 V0.9, V1.0 (Class 1)
    • 24-bit resolution, 102.4 kSa/s sampling rate per channel, 45 kHz bandwidth
    • <0.2° @ 10 kHz phase accuracy between channels of the same or any other Module
    • ±(10 V, 1 V and 100 mV) input ranges
    • There are 3 distinctive input mode options for both ICP® and voltage input modes:
      • Differential or Balanced Float (ICP® mode provides ±12 V excitation)
      • Single-Ended or Unbalanced Float  (ICP® mode provides 24 V excitation)
      • Single-Ended or Unbalanced Ground  (ICP® mode provides 24 V excitation)
    • Short and open circuit cable monitoring
    • Signal integrity circuit continuously monitors the input and disconnects sensitive circuits during overload conditions
    • Pre and post filter overflow monitoring
    • Selectable low and high pass digital filters
    • 2 MΩ differential and 1 MΩ single-ended input impedance
    • SMB connectors

    Downloads