MIC42X G2

In addition to providing excellent performance for microphone measurements, the MIC42X G2 Module also offers ICP^® and voltage input modes.

• With any 200 V or self-polarized microphones with preamplifier
• With any ICP^® based sensor commonly used to measure vibration, acceleration, force and pressure
• With any voltage source up to ±12 V in voltage input mode

• 2 channels
• 3 input modes of operation:
  • Microphone mode with 200 V or self-polarized microphone capsules with preamplifier
  • ICP® mode with 4 mA, 8 mA or 12 mA constant current at ±12 V or 24 V excitation
  • Voltage input mode with AC or DC coupling
• Supports TEDS IEEE 1451.4 V0.9, V1.0 (Class 1 and 2)
• 24-bit resolution, 204.8 kSa/s sampling rate per channel, 90 kHz bandwidth
• <0.2° @ 10 kHz phase accuracy between channels of the same or any other Module
• ±(12V, ±1.2V, 120 mV) input ranges
• ±14.5V at 40 mA microphone pre-amplifier excitation voltage
• 0 or 200 V polarization output
• Microphone calibration output to inject test signals into microphone preamplifiers
• Exceptionally low distortion and noise design
• There are 3 distinctive input mode options for both ICP® and voltage input modes:
  • Differential or Balanced Float (±12 V excitation)
  • Single-Ended or Unbalanced Float (24 V excitation)
  • Single-Ended or Unbalanced Ground (24 V excitation)
• Software selectable connection of cable shield to Ground Short and open circuit cable monitoringSignal integrity circuit continuously monitors the input and disconnects sensitive circuits during overload conditionsPre and post filter overflow monitoringLow power consumptionLemo 7-way EGG.1B connectors